Physics - Mechanical Properties of Fluids
Practise 110 TS EAMCET previous year questions on Mechanical Properties of Fluids, compiled from papers spanning 2001 to 2025. Each question is pulled directly from the actual exam paper it appeared in, so you're practising in the exact style and difficulty TS EAMCET tests.
Mechanical Properties of Fluids has been asked in 24 of the 24 years of TS EAMCET papers analysed (2001–2024), with 110 questions in all. 35% of them were easy, 50% moderate and 15% tough. Most of its questions came from 2022, with 12 questions that year. In the last three years (2022–2024) it had 32 questions across 17 papers, about 1.9 per paper.
The chapter's 7 topics are not weighted equally: Surface tension (41 questions, 37%), Viscosity (19 questions, 17%), and Efflux of liquid (14 questions, 13%) have been asked the most. Surface tension has also led over the last five years, with 19 questions. Surface tension has produced the most tough questions (7).
- 1A wooden block of outer volume 1 litre and specific gravity having a cavity floats with half of its volume immersed in water. Then the volum04 May, 2025 (M)Archmidies Principle
- 2When ' ' identical mercury drops combine to form a single big drop04 May, 2025 (M)Surface tension
- 3A cube of side 40 cm is floating with th of its volume immersed in water. When a circular disc is placed on the cube, it floats with th of i04 May, 2025 (E)Archmidies Principle
- 4The maximum length of water column that can stay without falling in a vertically held capillary tube of diameter 1 mm and open at both the e04 May, 2025 (E)Surface tension
- 5An air bubble rises from the bottom to the top of a water tank in which the temperature of the water is uniform. The surface area of the bub03 May, 2025 (M)Pressure and thrust
- 6If is the work done in increasing the radius of a soap bubble from ' ' to ' ' and is the work done in increasing the radius of the soap bubb03 May, 2025 (M)Surface tension
- 7A thin film of water is formed between two straight parallel wires each of length 8 cm separated by distance of 0.6 cm. The work done to inc03 May, 2025 (E)Surface tension
- 8A rain drop of diameter 1 mm falls with a terminal velocity of in air. If the coefficient of viscosity of air is , the viscous force on the 03 May, 2025 (E)Viscosity
- 9The work done in blowing a soap bubble of diameter 3 cm is (Surface tension of soap solution )02 May, 2025 (M)Surface tension
- 10If the terminal velocity of a metal sphere of mass 8 g falling through a liquid is , then the terminal velocity of another sphere of mass 6402 May, 2025 (M)Viscosity
- 11Water is filled in a tank up to a height of 20 cm from the bottom of the tank. Water flows through a hole of area at its bottom. The mass of02 May, 2025 (E)Efflux of liquid
- 12For which of the following Reynold's number, a flow is streamlined?02 May, 2025 (E)Viscosity
- 13A big liquid drop splits into ' ' similar small drops under isothermal conditions, then in this process11 May, 2024 (M)Surface tension
- 14A wooden cube of side 10 cm floats at the interface between water and oil with its lower surface 3 cm below the interface. If the density of11 May, 2024 (M)Archmidies Principle
- 15A big liquid drop splits into ' ' similar small drops under isothermal conditions, then in this process10 May, 2024 (M)Surface tension
- 16A wooden cube of side 10 cm floats at the interface between water and oil with its lower surface 3 cm below the interface. If the density of10 May, 2024 (M)Archmidies Principle
- 17The work done in blowing a soap bubble of volume is . The work done in blowing the bubble of volume from the same soap solution is10 May, 2024 (E)Surface tension
- 18Three identical vessels are filled up to the same height with three different liquids and of densities and , then the pressure at the bottom10 May, 2024 (E)Pressure and thrust
- 19The height of water level is a tank of uniform crosssection is 5 m . The volume of the water leaked in 5 s through a hole of area made at th09 May, 2024 (M)Efflux of liquid
- 20The work done in increasing the diameter of a soap bubble from 2 cm to 4 cm is (Surface tension of soap solution )09 May, 2024 (M)Surface tension
- 21The excess pressure inside a soap bubble of radius 0.5 cm is balanced by the pressure due to an oil column of height 4 mm . If the density o09 May, 2024 (E)Surface tension
- 22Water flows through a horizontal pipe of variable crosssection at the rate of litre per minute. The velocity of the water at the point where09 May, 2024 (E)Hydrodynamics
- 23A cylindrical vessel, open at the top, contains 15 litres of water. Water drains out through a small opening at the bottom. 5 litre of water14 May, 2023 (M)Pressure and thrust
- 24A cylinder of mass and material density hanging from a string is lowered into a vessel of cross-sectional area A containing a liquid of dens14 May, 2023 (M)Pressure and thrust
- 25When a large bubble rises from the bottom of a lake to the surface, the volume of the bubble becomes 5 times its volume at the bottom of the14 May, 2023 (E)Efflux of liquid
- 26A water drop breaks into 64 identical droplets of each surface area . If the surface tension of water is , the increase in the surface energ14 May, 2023 (E)Surface tension
- 27A vessel having small hole in the bottom has to hold water without leakage, if water is poured to a height of 7 . Then the radius of the hol13 May, 2023 (M)Pressure and thrust
- 28The angle of contact is when a cylindrical rod is vertically placed in a liquid. If the same rod is placed horizontally in the liquid, then 13 May, 2023 (E)Surface tension
- 29In a well pressure at a point below the surface of water is13 May, 2023 (E)Pressure and thrust
- 30A straw of circular cross-section of radius and negligible thickness is dipped vertically into a liquid of surface tension . If the contact 12 May, 2023 (M)Surface tension
- 31A solid metal sphere released in a vertical liquid column has attained terminal velocity in the downward direction. The magnitudes of viscou12 May, 2023 (M)Viscosity
- 32Three identical vessels are filled with three liquids A, B, and with equal masses but having densities and respectively. If then the pressur12 May, 2023 (E)Pressure and thrust
- 33A venturimeter has a pipe diameter of and a throat diameter of . Velocity of water in the pipe section is . The pressure drop, between pipe 20 Jul, 2022 (M)Hydrodynamics
- 34A soap bubble of initial radius is to be blown up. The surface tension of the soap film is . The surface energy needed to double the diamete20 Jul, 2022 (M)Surface tension
- 35A wide cylindrical vessel 50 cm in height is filled with water and rests on a table. Assuming the viscosity to be negligible, find at what h20 Jul, 2022 (E)Surface tension
- 36A spherical drop of radium r is divided in to 8 equal droplets. If the surface tension is S, then the work done in the process will be20 Jul, 2022 (E)Viscosity
- 37A liquid flows steadily through a cylindrical pipe having a radius 2R at a point A and radius R at point B farther along the flow direction.19 Jul, 2022 (M)Hydrodynamics
- 38A piece of metal has a weight of in air and in a liquid of density at . When the temperature of the liquid is raised to the metal piece has 19 Jul, 2022 (M)Archmidies Principle
- 39Consider an increase of in each of radius of artery, viscosity of blood and density of blood respectively. The percentage change in flow rat19 Jul, 2022 (E)Viscosity
- 40A metal cube of side rests on a film of a liquid of thickness . If upon applying a horizontal force of magnitude the cube slides with a cons19 Jul, 2022 (E)Viscosity
- 41A large storage tank, open to the atmosphere at top and filled with water, develops a small hole in its side at a point 20 . 0 m below the w18 Jul, 2022 (M)Efflux of liquid
- 42An air bubble of radius 1 mm is at a depth of 8 cm below the free surface of a liquid column. If the surface tension and density of the liqu18 Jul, 2022 (M)Surface tension
- 43A hollow spherical body of outer and inner radii of 4 cm and 2 cm respectively floats half submerged in a liquid of density 2 . 0 g cm - 3 .18 Jul, 2022 (E)Archmidies Principle
- 44What is the terminal velocity of a rain drop of radius 0 . 02 mm ? [Note that the coefficient of viscosity of air is 1 . 8 10 - 5 N m - 2 , 18 Jul, 2022 (E)Viscosity
- 45The work done in breaking a drop of liquid of radius (Surface tension ) into 64 equal drops is06 Aug, 2021 (M)Surface tension
- 46In a horizontal tube the water pressure changes by between and as shown in figure below. The cross-sectional areas at and of the tube are an06 Aug, 2021 (M)Hydrodynamics
- 47A shower head has 25 circular openings, each with radius . The shower head is connected to a pipe with radius . If the speed of the water in06 Aug, 2021 (E)Pressure and thrust
- 48A block of material with density is placed on a fluid of density . The fraction of volume of the piece of material outside the fluid is06 Aug, 2021 (E)Viscosity
- 49Two stars of equal masses M are orbiting in a circle of radius R . Their orbital time period is proportional to05 Aug, 2021 (M)Surface tension
- 50Two springs of force constants K 1 and K 2 are loaded with weights W 1 and W 2 respectively. Assume that length of each string is increased 05 Aug, 2021 (M)Pascal's Law
Frequently Asked Questions
1.How many questions are available for Mechanical Properties of Fluids?
This chapter includes 110 questions compiled from TS EAMCET papers spanning 2001 to 2025.
2.Are these questions only from TS EAMCET, or from other exams too?
These are TS EAMCET questions specifically for the Mechanical Properties of Fluids chapter. Questions from other exams like JEE Main or NTA Abhyas (JEE Main) are organised separately under their respective exam sections.
3.Is Mechanical Properties of Fluids an important chapter for TS EAMCET Physics?
Mechanical Properties of Fluids has appeared in 25 of the 25 years of TS EAMCET papers covered here, with 110 questions across 61 papers - about 2 per paper it appears in.
4.What is the difficulty level of Mechanical Properties of Fluids questions in TS EAMCET?
Of the 110 questions analysed for this chapter, 35% are easy, 50% moderate and 15% tough. 2022 had the most, with 12 questions.
5.Which topics in Mechanical Properties of Fluids should I focus on?
These topics have carried the most weightage in Mechanical Properties of Fluids:
- Surface tension - 41 questions (37%)
- Viscosity - 19 questions (17%)
- Efflux of liquid - 14 questions (13%)
- Surface tension has produced the most tough questions (7).
6.Is Mechanical Properties of Fluids's weightage in TS EAMCET going up or down?
Across all 61 papers analysed, Mechanical Properties of Fluids has averaged about 1.8 questions per paper. In the last three years (2022–2024), that average has stayed about the same, at about 1.9 questions per paper. Use the year-wise numbers on this page for the exact trend before you decide how much time to give it.